General
The idea behind the PEC Sweetfilter® II is to provide a localized source of odor control for residential and commercial vents. High efficiency chlorine dioxide (ingredients have been determined to be safe for general use... click here for GRAS documentation) and media canister type absorbers are mounted on the roof vent. Foul air passes through the absorber and odors are removed by the ox gel mix.

Operational Features

• Sweetfilter II Filter continuously cleans circulation air and includes oxgel pellets bag.
• Canister easily slides onto roof vent.
• Design allows capture of specific gas molecules such as: Ammonia, aldehydes, carbon dioxide, carbon monoxide, ethylene, hydrogen sulfide, ketones, and mercaptans among others.
• REGENERATION: Chlorine dioxide ox gel pellets requires periodic replacement.

Description

• Air intake grille (A) = 4.25 inches I.D.
• Chlorine dioxide ox gel canister (B)= 4.6 inches O. D.
• Roof vent pipe coupling connection (C) = 4.50 inches I.D.(invert allows for 2" insert of existing vent stack)
• Overall length (D) =6.0 inches
• Media fill (1lb), ship weight 3.5 lbs.

Safety Tips

• DO NOT store or expose unit to any source of direct heat such as radiators or heat vents.
• DO NOT expose unit to any inflammable liquids/gases as unit will rapidly absorb them diminishing unit capacity
• DO NOT store units in an unventilated area. Stored units will produce strong odors during storage.
• The unit should be operated when the building/vent temperature is between 60F and 95F
• If the building/vent temperature is below 60F ice may form on the air intake grille, above 95F odor absorbtion is reduced.

Maintenance

• Annually inspect and clean the air intake grille.
• Visually inspect the units after inclement weater to insure proper operation.
• Since ice/snow storms can temporarily block the air intake grilles interrupting normal air circulation and because little or no offensive odors are produced during the winter seasons, it is recommended that the canisters be removed and stored during all winter seasons. Winter storage will double the ability to absorb odors.

Installation

• Run water down all plumbing drains to insure water seals are full and working. Water seals dry out quickly in unused drains. We recommend that infrequently used drains recieve a quarterly application of www.bluesealliquid.com
• Keep the unit in the vertical postion during transportation.
• Remove shipping covers from air intake grilles (A) and on bottom of Vent connections (C).
• Turn screw counter-clockwise on (C) place unit on vent pipe and turn screws clockwise until secure.

PEC Sweetfilter II Instruction Manual (page 2 of 2)

• Unit does not work....inspect and clean the air intake grille.
• Capacity diminished....short term return of odors is due to overload of filter and online recovery time is needed. Long term, (more than two weeks) return of odors requires larger units or recharge of the ox gel. Click here to purchase single 4" refills regeneration chlorine dixoide ox gel pellets... (requires removal of unit from vent stack for regeneration). For bulk refill OX-PELLETS click here.

• PEC warrants each product and any parts thereof sold by it to be free from defects in materials and workmanship under normal use and service for TWELVE (12) MONTHS from the date of delivery to the original purchaser at retail subject to the following terms and conditions:
• What is covered: Product or parts thereof which are defective in workmanship.
• What is NOT covered: This warranty does not extend to any defect due to the negligence of others: failure to install, operate, or maintain unit in accordance with installation instructions (operating and installation instructions are supplied with each unit): unreasonable use, accidents, alteration, use of unauthorized or non-standardized PEC parts and accesories; air flow malfunction due to plugged grille or canister, i.e., as resulting from large power outages, inclement weather, freezing, or other acts of god.
• Who is covered: The original purchaser at retail.
• What we will do: PEC will repair or replace, at its option, all defective parts free of charge that are by this limited warranty on a carry-in basis, to your nearest authorized dealer or distributor.
• What you must do for warranty service: You must return the defective product or part to any authorized dealer or distributor of PEC products with this limited warranty and a copy of your documents evidencing the date of the products delivery. If service is not available locally you must contact our customer relations department for a RMA# and instructions on shipment of used units at:
  
  PEC
  1520 N. 6th Street
  Springfield, IL. 62702
  tel. (888) 262-4726.....toll free voice mail/fax (866) 422-0018
  
  
  CAUTION !!! DO NOT RETURN USED UNITS FOR ANY REASON BY USPS MAIL! NO SHIPMENTS WILL BE ACCEPTED WITHOUT A RMA#!!!
  
  

  ---

  
  
  THE FOREGOING EXPRESSES ALL OF PEC'S OBLIGATIONS AND LIABILITIES WITH RESPECT TO THE QUALITY OF PRODUCT FURNISHED BY IT. ALL OTHER WARRANTIES, EXPRESS OR IMPLIED, INCLUDING THE WARRANTIES OF MERCHANTABILITY OR FITNESS FOR A PARTICULAR PURPOSE ARE DISCLAIMED. PEC SHALL NOT BE LIABLE FOR THE LOSS OF ANY PRODUCT, INCONVENIENCE, LOSS OR ANY OTHER DAMAGES, DIRECT OR CONSEQUENTIAL ARISING OUT OF, THE USE OF, OR INABILTY TO USE, THE PRODUCT OR DAMAGES RESULTING FROM OR ATTRIBUTABLE TO DEFECTS IN THE PRODUCT.

Go to... http://www.sewerodor.com

• MATERIAL SAFETY DATA SHEET OX PELLETS
• OXIDIZING/POLISHING MEDIA FOR MALODOR CONTROL PRODUCT INFORMATION
• Trade Name: Ox Pellets ™
• Name and/or Family Description: Oxidizing Media for Malodor Control
• Emergency Phone: (800) 424-9300 (CHEMTREC) COMPOSITION (OSHA Hazardous Ingredients) COMPONENTS WT% Component A 54.2 The specific identities of certain components of this formulation are withheld as trade secrets in accordance with 29 CFR 1910.1200. Component B
• 11.5 HAZARDS IDENTIFICATION Hazard Summary: Sand-colored, granular solid with chlorine-like odor. This product contains corrosive material absorbed onto an absorbent material. If soaked in water, the resulting solution may be corrosive to the skin and eyes on contact. Do not mix with organic material or acids as an explosion could result.
• Potential Health Effects: Eyes: May be corrosive. Skin: May be corrosive to skin. Ingestion: Harmful if swallowed. Can irritate the nose and throat. Inhalation: May be irritating to eyes and respiratory tract.
• FIRST AID MEASURES Eyes: Immediately wash eyes with water for at least 15 minutes. Lift upper and lower lids and rinse well under them. Get immediate medical attention. Skin: Wash off in flowing water or shower. If irritation persists, get medical attention. Inhalation: Remove from exposure. If individual is not breathing, administer cardiopulmonary resuscitation (CPR) and get immediate medical attention. If individual is breathing, but with difficulty, get medical attention. Ingestion: Do not induce vomiting. Do not give anything by mouth to an unconscious person. Immediately drink large quantities of water or milk. Get medical attention.
• FIRE FIGHTING MEASURES Flammable Properties: This product is non-flammable. Flash Point: None. Method Used: Not applicable. Flammable Limits: Not applicable. Product is not flammable. Extinguishing Media: Water fog. No dry chemical, CO 2 or halon. Fire & Explosion Hazards: Although this product is not combustible, soaking it in water and allowing it to evaporate can leave a residue that is an oxidizer. Solutions can react with acids and organic material to liberate chlorine dioxide, which is an explosion hazard. Fire Fighting Equipment: Wear full bunker gear including a positive pressure self-contained breathing apparatus.
• ACCIDENTAL RELEASE MEASURES Scoop up spilled dry material and place in an appropriate container for disposal. If the material is wet, the spill area must be rinsed thoroughly, as a corrosive residue may remain. Do not allow spilled wet material to evaporate to dryness.
• HANDLING AND STORAGE Store in a cool, dry place. Do not allow material to get wet, as a corrosive solution may result. Store separately from acids, reducing agents, organic material such as solvents, fuel, wood (i.e., pallets) and paper. Do not store in steel drums. After handling, wash hands with soap and water.
• EXPOSURE CONTROL/PERSONAL PROTECTION Respiratory Protection: If dust appears in handling operations, wear a NIOSH approved respirator with replaceable dust filters. Skin Protection: Gloves are not normally necessary unless handling this material when wet. If wet, wear impervious gloves.
• Eye Protection: If dust appears in handling operations, wear goggles or safety glasses. Exposure Guidelines: PEL/TLV have not been established for the product as a whole. Component OSHA PEL/TWA ACGIH TLV/TWA Crystalline silica (Cristobalite) 0.05 mg/m 3 (as respirable dust) 0.05 mg/m 3 Crystalline silica (Quartz) 0.1 mg/m 3 (as respirable dust) 0.1 mg/m 3
• Engineering Controls: Use with adequate ventilation. Local exhaust ventilation may be necessary for operations in which dust is generated.
• PHYSICAL AND CHEMICAL PROPERTIES Appearance: Sand-colored granular solid Odor: Chlorine-like odor/minty Boiling Point: Not applicable Solubility in Water: Insoluble Specific Gravity: 6.55 lbs/gal (bulk density) Freezing Point: Not applicable pH: Not applicable % Volatile: 34.3%
• STABILITY AND REACTIVITY Stability: (CONDITIONS TO AVOID) stable. Incompatibility: (SPECIFIC MATERIALS TO AVOID) organic combustible materials, decomposed acids, exposure to direct sunlight. Hazardous Decomposition Products: Chlorine dioxide and chlorine.
• TOXICOLOGICAL INFORMATION Toxicological data is not available for the product as a whole. The following information is provided for Component B. LD 50 (oral) Rats: 165 mg/kg Toxic Effects: Liver - Jaundice, other or unclassified: Kidney, ureter, and bladder - interstitial nephritis; biochemical. LD 50 (oral) Mouse: 350 mg/kg LD 50 (oral) Guinea Pig: 300 mg/kg
• DISPOSAL CONSIDERATIONS Water Management Information (Disposal): Any disposal practice must be in compliance with local, state and federal laws and regulations (contact local or state environmental agency for specific rules).
• TRANSPORT INFORMATION
• TRANSPORTATION AND HAZARDOUS MATERIALS DESCRIPTION:
• DOT SHIPPING NAME. Corrosive solid, n.o.s. (contains Sodium chlorite, mixture) UN ID NO: 1759 Hazard Class: 8 (Corrosive); II
• REGULATORY INFORMATION
• OSHA HAZARD COMMUNICATION RULE, 29 CFR 1910.1200: According to the OSHA Hazard Communications standard, this product is considered hazardous because it contains Component B and trace amounts of crystalline silica.
• CERCLA/SUPERFUND, 40 CFR 117.302: This compound contains NO compounds subject to 40 CFR 117.302.
• SARA 313 INFORMATION: This product contains the following toxic chemicals subject to the reporting requirements of section 313 of the Emergency Planning Community Right-To-Know Act of 1986 and of
• 40 CFR 372: None.
• TOXIC SUBSTANCES CONTROL ACT (TSCA): The ingredients of this product are all on the TSCA Inventory list.
• CALIFORNIA PROPOSITION 65: The following statement is made in order to comply with the California Safe Drinking Water and Toxic Enforcement Act of 1986: “Notice: This product contains a chemical known to the State of California to cause cancer, birth defects, or other reproductive harm.” [22 CCR 12705 (b)]. This product contains crystalline silica.
• OTHER INFORMATION NFPA Rating HMIS Rating Fire 0 Health 2 Health 2 Flammability 0 Reactivity 2 Reactivity 2 Hazard OX, Corrosive Protection A
• This data is furnished gratuitously independent of any sales of the product and only for your investigation and independent verification. While the information is believed to be correct, P.E.C., Inc. shall in no event be responsible for any damages whatsoever, directly or indirectly, resulting from the publication or use of or reliance upon data contained herein. No warranty, either expressed or implied, of merchantability, of fitness, or of any nature with respect to the product, or to the data is made herein.